V6 3.8 to 5.0 v8

Status
Not open for further replies.

3.8 to 5.0swap

Not-quite-so-new-guy
Feb 3, 2019
13
1
3
Hello i swapped my v6 to a 5.0 v8 i have a question when removing the v6 wiring harness i had to cut 2 wires that ran to a sensor or plug on the side of the transmission now i cant find where they connect to on the v8 wiring harness your help is greatly appretiated thank you
 

Clone TIE Pilot

Comic Book Super Hero
Aug 14, 2011
3,827
2,565
113
Galaxy far far away
You didn't need to cut anything, all wiring harnesses are easily removed. The plug on the side of the transmission is for the torque converter lockup solenoid.
 
  • Like
Reactions: 1 users

3.8 to 5.0swap

Not-quite-so-new-guy
Feb 3, 2019
13
1
3
You didn't need to cut anything, all wiring harnesses are easily removed. The plug on the side of the transmission is for the torque converter lockup solenoid.
The new harness dosent have that plug i checked it and it dosent seem like anything was cut from it
 

Clone TIE Pilot

Comic Book Super Hero
Aug 14, 2011
3,827
2,565
113
Galaxy far far away
Are you sure its a G body harness? Could be a harness for a manual trans F body?
 
Status
Not open for further replies.

GBodyForum is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to amazon.com. Amazon, the Amazon logo, AmazonSupply, and the AmazonSupply logo are trademarks of Amazon.com, Inc. or its affiliates.

Please support GBodyForum Sponsors

Classic Truck Consoles Dixie Restoration Depot UMI Performance

Contact [email protected] for info on becoming a sponsor