Tuning an Olds engine, Is this accurate?

Status
Not open for further replies.

SRD art

G-Body Guru
Jun 16, 2011
550
442
63
St. George, UT
I just watched a video about tuning an Olds engine. Fellow says to set timing by idle rpms rather than with a timing light and you're good to go. I want to get my stock 307 running at it's peak, and bumping up timing advance was on my list.

Any truth to what this fellow says to do?

 
Last edited:

69hurstolds

Geezer
Supporting Member
Jan 2, 2006
8,089
17,299
113
Other than apparently sounding like he has lung cancer, it was hard to listen to.

Olds engines come with a variety of methods for advance. Some run off ported vacuum, some run of ported OR manifold vacuum, and some have HEI with CCC that needs none of that. And don't forget the mechanical advance. It's usually wiser to include total advance as well. And 4 speed cars usually are set differently than automatics. Some have TVS's that swap your vacuum source when the engine coolant is too warm.

It may work on ONE specific car he might have worked on when he was 14 or so. But it doesn't apply to all Olds engines.

GM assigns tune-up specifications for all their engines. Follow those instructions for your specific engine application and you'll be further ahead than listening to this guy. Sounds like one of those "you might get by listening to this bunk" but if it were as simple as that, GM would put that in their instructions.
 
  • Like
Reactions: 3 users

Texas82GP

Just-a-worm
Apr 3, 2015
7,981
18,676
113
Spring, Texas
I just watched a video about tuning an Olds engine. Fellow says to set timing by idle rpms rather than with a timing light and you're good to go. I want to get my stock 307 running at it's peak, and bumping up timing advance was on my list.

Any truth to what this fellow says to do?

OzDFAZ.gif
 
  • Like
  • Haha
Reactions: 2 users
Oct 14, 2008
8,806
7,746
113
Melville,Saskatchewan
He was hard to follow. I assume your car is still CCC? What year? I find low compression Olds engine like a lot of timing, it helps part throttle response, talking around 60 degrees. I ran 20+ base and 38 to 40 with mechanical advance on the Street felt best but 36 was faster at the track. 85 and up have 60 degrees of advance part throttle I believe already. Even the earlier 307's have aggressive advance, high 50's. A couple of degrees might help but only so much.
 
  • Like
Reactions: 1 users

SRD art

G-Body Guru
Jun 16, 2011
550
442
63
St. George, UT
He was hard to follow. I assume your car is still CCC? What year? I find low compression Olds engine like a lot of timing, it helps part throttle response, talking around 60 degrees. I ran 20+ base and 38 to 40 with mechanical advance on the Street felt best but 36 was faster at the track. 85 and up have 60 degrees of advance part throttle I believe already. Even the earlier 307's have aggressive advance, high 50's. A couple of degrees might help but only so much.
Mine is an 84.

Wow! that's a lot of advance compared to what I'm used to in my SBCs.
 
  • Agree
Reactions: 1 user

fleming442

Captain Tenneal
Dec 26, 2013
13,046
24,214
113
I haven't responded because I just don't know Jack about the CCC. I ASSUME that any changes would be "corrected" by the computer if so equipped. olds307 and 403 is correct, though. Low compression Olds engines LOVE timing. The rule of thumb is 16-20⁰ initial, 34-36⁰ total w/centrifugal, and the moon with vacuum applied.
 
  • Like
Reactions: 4 users
Status
Not open for further replies.

GBodyForum is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to amazon.com. Amazon, the Amazon logo, AmazonSupply, and the AmazonSupply logo are trademarks of Amazon.com, Inc. or its affiliates.

Please support GBodyForum Sponsors

Classic Truck Consoles Dixie Restoration Depot UMI Performance

Contact [email protected] for info on becoming a sponsor