Recent content by fastNYsix

My 2011 Silverado melted the fuse box. I never found the source. There must be a problem with these because there’s never one to be found at junkyard. Mines a 5.3

simple green in a foam cannon.

The GM EOS worked great for me.

85 regal. Not the best before pictures. The last time it was registered was 2005. The original interior was really nice, so it ended up in a roller I bought. The original carbed na 3.8 ran perfect, so that also went into the roller.

I’m working on converting my regal to manual and would like to keep the factory console. Has anyone done this, I can’t find much info or pics. Thanks.

285 35 18 stock height. No notch, no fender roll, no rub on regal

has anyone purchased the repop taillights from gbody parts?

Awesome! Put me down for one also, if you decide to make some.

You got the p0521 code with gauge at half? Mine is at zero, even after the previous owner changed the afm plate and sensor. Any ideas on what else to look for? I'm replacing the oring and pump next. Can you run it without the screen? The previous owner left the used screen in the glovebox.

Took it down the track for the first time. I’m in the left lane. An older mopar in the right lane.

are they metal or plastic?

Not sure about those. I have a spare dash, I'll check it out.

I had a cam bearing fall out when I pulled cam. Block was fine. The new bearings went in tight. I’ve gone 5k miles on it.

I've had the little bar, the solid GN bar, and the 36mm f body bar. I prefer the bigger bar. I'm currently using the f body bar with bilsteins. I think it's a nice set up, I drive it daily in the summer. I haven't done control arms or tall ball joints yet.

Yes that is annoying. I meant nice in that there's a sharp cutoff, so I don't blind traffic. Its worth it for the high beams though. Can you adjust the rav 4 up a little bit?