Recent content by Happy camper

  1. Happy camper

    Maiting season. Back from the dead

    No reason, I just saw the c5 guys using this combo without adapters so I figured it would work with mine.
  2. Happy camper

    Maiting season. Back from the dead

    Vendor, there just your standard c5 caliper to blazer spindle bracket.
  3. Happy camper

    Maiting season. Back from the dead

    There above the rotor buy maybe 1/16 and right at the bottom of the rotor surface.
  4. Happy camper

    Maiting season. Back from the dead

    For the wheels im running no clearance issue. But if your talking about rotor to caliper, I had to just do a little on the outside inner edge
  5. Happy camper

    Maiting season. Back from the dead

    Still waiting on my new control arms and shock mounts. I haven't done much to the frame because of that . But did decide to upgrade those tiny c6 calipers and rotors. Ended up going with the blazer spindles, cadillac ats brembo calipers and c6 z06 rotors, hopefully they will look a little better...
  6. Happy camper

    BUILD THREAD RealDealRegal Small tire Drag build

    Looking good, that was alot of wire brushing
  7. Happy camper

    Longer wheel studs.

    Thank you .
  8. Happy camper

    BUILD THREAD “The Juggernaut”

    What is wrong with you? Your perfection makes me fill so inadequate when I work on my car. But seriously it's looking fantastic. I'm always impressed by your work, and it gives me the motivation to try and do better on my project.
  9. Happy camper

    Longer wheel studs.

    Hey everyone, I need to replace my front wheel studs for some longer ones. I'm looking at the doorman website and found this model# 610-323 the knurl is 12.8mm instead of 12.73mm will this work or does anyone else have a better recommendation. Thank you
  10. Happy camper

    Maiting season. Back from the dead

    Finally had a little time, and put the notch in, to clear the a/c compressor
  11. Happy camper

    BUILD THREAD RealDealRegal Small tire Drag build

    I'm getting ready to paint my frame, and was wondering how many qts. Of the eastwood chassis blk you used? Thanks
  12. Happy camper

    Maiting season. Back from the dead

    Motor ,transmission, and exhaust mocked up. Everything seems to fit . Now to pull it out and notch the frame for the A/C compressor.
  13. Happy camper

    Need some help

    Thank you.
  14. Happy camper

    Need some help

    Correct, after another look a few minutes ago with the mounts loose it still sits a little off center looks like the tail of the transmission is pointed towards the passenger side, but when the motor mounts are snuged up it really points to the passenger side.

Please support GBodyForum Sponsors

Classic Truck Consoles Dixie Restoration Depot UMI Performance

Contact [email protected] for info on becoming a sponsor