What did you do to your G-Body today? [2011-2018]

The wife turned it into a poster

Haven't made much Monte progress lately, lots of out of town work, (Montana, Nebraska, Arizona) , and had to rebuild the transfer case and rebearing the OD unit on my 05 Dodge due to a nagging leak between the trans and transfer case. But today, dammit, I got back under the Monte and removed the body crossmember under the rear seat, a job I've been dreading. You, know what, it wasn't that bad, drilled out about all the spotwelds from inside, removed it, cleaned up the pan and hit it with some POR 15. Tomorrow the new one goes in, one step closer to the body back on the frame. Pics to follow tomorrow.

pontiacgp said:

and this

Click to expand...

Uh, that's a Ford hammer....
This is a GM site.

Pulled the trans out of the crew cab Malibu. Got another one and swapped the valve body over. Now hopefully I can put it back together and drive it while I learn how to rebuild to 4l80s.

Nothing sadly....

Finally got my suspension finished on my LS1 swapped Olds. Went UMI suspension with Viking coil-overs. Front is a little low so adjustments are in order but she's almost there...

Low? How about almost low enough?

I started work today on sheet metal. I'm expecting new floor pans and rocker panels at the end of the month so I'll be reusing the seat brackets and floorboard braces, so I'm drilling these out prior to cutting the floor out for a replacement.

pagrunt said:

The old universal fix-it tool

Click to expand...

Ah... The Ford Wrench.

tc1959 said:

The wife turned it into a poster View attachment 88805

Click to expand...

your poor dogs are going to think the TV is stuck on one channel.......