well finally getting ready to do a rebuild on a 7.5 rear. I have grand national axles 28 spline and s Torsen posi out of a camaro to go in it. I am going to buy a summit ring and pinion and girdle cover as well. What is the best kit to buy that is complete?
I have a 30 over 350 flat tops 041 GM heads big valves with port work. I am around 10 to 1 compression with 1.5 roller rockers. I am running an comp magnum 292 h cam. When I swapped motor over I changed from vac advance to a summit mech advance distributor. Where should I be with this setup? I...
I bought a summit racing fan relay and the switch is bad. If you ground the wire the fan comes on so I know my relay is good. I have read that these things take a crap quit often. Is there a way to test with an ohm meter? This one has just the one spare connector. Also I installed it in back of...
I ran across a nice set of seats on Craigslist. Anyone install any of these in there ride? I have a Monte Carlo that has red interior and I am wanting to switch to grey or black so I have been looking on internet.
Does anyone have experience with putting 28 spline Grand national axles in a 7.5 housing? I have a torsen posi 28 spline to go with it. A buddy put a posi from a camaro in an s10 dropped right in but it had 28 spline axles. Will I need different or special bearings?
I was looking at posts about 8.5 and had a couple of thoughts. Some had asked this in another tread and it was not answered. Are the tubes on a 7.5 rear the same as 8.5? What about other than grand/442 rears? If so they couldn’t they be swapped?
I have umi 2" drop springs on the car now which sets it about an inch lower than the stock front. I would like it set even so what spring for one inch drop? I heard moog 5413 will get you inch. The car will be street and a little strip..
I was checking out the post on the kilduff shifter and got to wondering are there other companies makeong shifters I don’t know about? Of course I know about the Hurst and B&M shifters but what else is out there? Anyone have pictures?
I have an 86 Monte Carlo SS the problem I have is I am 6’2 about 320 lbs. so there is not much headroom in the car. Anyone have ideas for lowering the seats? I thought about sliding them back and bolting them to floor? Thoughts?
Were does the battery power connect to the fuse block? I have asked this in another thread did not get a big response. The back of the plug is not in great shape but till I can get another one i just need to know were to hook it in?
were should the power be hooked to the fuse from battery?long story short car been setting a while and looks like plug connector with all the wires on firewall is shot.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.