Search results

The metal bracket that is in your second picture goes where the plastic battery hold down is bolted at. The hole that his higher is for the stud on the header panel and the lower one goes to the core support or vise versa. In the picture you are holding it wrong and should be turned to where...

That run is with the original Holley mufflers that come with the exhaust kit? They're advertised as aggresive-moderate and I thought they would sound a lot louder that.

What type of mufflers do you have?

Sounds sweet!!!

Finally!!! This is without exhaust. Boy was I happy it cranked right over without any problems.

It does not. You will need to take the interior panel around the window and remove the nuts and some small brackets to remove it. There is some sticky window sealant that is hard to get off and extremely sticky when taking the glass out, so make sure you don't get it on anything.

Thanks for the info...

Thanks, I do plan on going with an aftermarket HVAC system next year. for the lower hose I used Gates 22354.

What did you do to wire it in? I have a three way connector but I would rather use something else. I think I will try to remove the wire from the switch connector and tie them both together and then reinsert the terminal at the connector.

Yes the O2 sensor is snug in the header collector. I will be adding coolant during lunch and let it sit until after work. I still had to install the 10 micron fuel filter to the fuel system. I powered the Terminator, screen came on along with the LED lights on the ECU but I didn't program it...

I really want to crank her over this week. I still need cooling fans and exhaust. I have to wait until the end of the month to buy the exhaust system, so I bought a 24 inch long piece of exhaust pipe to put on the header. I have to prime the engine, add fluids, and set up the Terminator. I...

Just a lil update...

Radiator, hoses, air intake w/filter, spark plug wires and boots are all on order. I'm hoping all goes well and I can crank her up this Saturday... I still have some wiring to do and tightening up a few nuts and bolts... I'm going to strap on three feet of of 3 inch exhaust piping until I...

This is how far I've gotten these past months. I have work left on the harness and wiring, power steering hose, vacuum hoses. Things I need are radiator & hoses, fans, cold air intake, exhaust system and driveshaft.

Sweet, I like to think that painting is like riding a bike...she looks good and I can't wait to see her painted! Keep us posted and welcome to the forum!

I sent an email to Holley asking the same question about a week or two ago. About 15 minutes after I posted the question here I recieved an email responding it will be okay to install the MAT sensor on the intake tube.

Anyone using a FAST composite intake or the MSD LS1 intake and the Terminator X On the Terminator X it requires a MAT sensor on the intake manifold but I'm using the MSD Airforce intake and it doesn't have a place to install a MAT sensor, Should I just mount a sensor into the intake tube...

Sweet ride!

Did you resolve your issue?

I managed to install the intake, injectors, fuel rails, steam vent assy, and both headers. The headers slid right in after I raised the car another six inches they fit like a glove. If I have a chance Saturday I will take care of the fuel pump/sending unit, fuel plumbing and tank.