Search results

  1. ChetC

    What did you do to your non-G body project today? [2020]

    Finished building my 1/10 scale RC buggy
  2. ChetC

    Cutlass running rough need help

    Went for a 300mile trip to the family cottage and back home with no issues. Went ahead and put new EGR valve on it today just for precaution. Thank u everyone that chimed in, very much appreciated!
  3. ChetC

    Cutlass running rough need help

    So after starting it and shutting it off through out the day it’s all the sudden running normal after starting it this last time. Took it for a ride shut it off started it back up and still running fine! No idea what changed.
  4. ChetC

    Cutlass running rough need help

    So I’m assuming I did this correct? If so the wires are all good. Replaced ignition coil and module today still running the same! Where do I go from here? Timming?
  5. ChetC

    Cutlass running rough need help

    How do I do an ohm resistance test? I have an ohm meter but don’t really know how to use it lol. So far I put a new cap, rotor and coil in it and it hasn’t changed anything
  6. ChetC

    Cutlass running rough need help

    Wires all look good. Neighbor told me to pull wires off one by one and if the car idled different that cylinder was firing, if I’d didn’t change then that cylinder wasn’t firing... so I did this and apparently 4 out of 8 aren’t firing. I’m very confused
  7. ChetC

    Cutlass running rough need help

    Try to make this short! So I got off the freeway the other day and pulled up to the light and the car was idling really rough! Gave car complete tune up last year. Pulled cap off and this is what I find. So I replace cap rotor and ignition coil and still no change!
  8. ChetC

    What did you do to your G-Body today? [2011-2018]

    Installed my Billet Specialties steering wheel and billet door vents and door strickers!
  9. ChetC

    What did you do to your G-Body today? [2011-2018]

    Rear UMI 1” sway bar and rear boxed trailing arms
  10. ChetC

    What did you do to your G-Body today? [2011-2018]

    Shocks all way round, added inner fender braces, 1 1/4 front sway bar, new end links, new Jeep steering shaft upgrade. It was a good day! Huge difference in ride and handling! Sent from my iPhone using Tapatalk
  11. ChetC

    What did you do to your G-Body today? [2011-2018]

    Over the past week or so I've been doing some small things! Blacking out under the hood! Love how it looks! Painted rear reverse light assembly and redid the red stripe around it. Last I did some undercoating!
  12. ChetC

    What did you do to your G-Body today? [2011-2018]

    Cleaned up engine bay today! Still wanna get it a little better but it turned out good for a quickie!
  13. ChetC

    What did you do to your G-Body today? [2011-2018]

    Started leaking, bypassed for now till I replace it
  14. ChetC

    What did you do to your G-Body today? [2011-2018]

    Swapped out the factory air cleaner
  15. ChetC

    What did you do to your G-Body today? [2011-2018]

    Installed LED headlights
  16. ChetC

    Hello from Monroe MI!

    Welcome from St. Clair Shores Michigan. Nice car! Love the name u gave it and how u came up with it! Classic!

Please support GBodyForum Sponsors

Classic Truck Consoles Dixie Restoration Depot UMI Performance

Contact [email protected] for info on becoming a sponsor