Search results

  1. Mike Geepers

    New motor in a 78 monte

    Hello forum, long time lurker here, and being the owner of a 78 monte carlo this is my go-to place for tech help. Lately, my 305 has been showing its age and i have decided to do a motor swap to a 350. Let me start by stating what i want. I want to have 20inch rims so i need more get up and go...
  2. Mike Geepers

    TH350 torque converter bolts

    Hello forum, I have a quick question. I am in the middle of a trans swap (th200 to 350) and im all set up except...my bolts dont want to thread in the torque converter. Converter has holes welded, not flanges. I bought trans whole, and when i went to replace bolts the ARP bolts would not fit...
  3. Mike Geepers

    GN Rear end

    Hello forum, I have a chance to buy a GN rear end in my area. My car is a 78 MC with a rebuilt 305 and edelbrock top. Th200 trans, nothing special but it shifts good (eventually want a 700r4 conversion) The rear end is listed as a GN posi rear end with 3.42 gears and aluminum drums. It looks...
  4. Mike Geepers

    Driver door is sagging

    Hello forum, I have a 78 monte and the driver door is sagging. I think its sagging from the rolling pin on the door, but no auto parts store carries that type of pin. Does it even change out or do i just change the other 2 pins located farther back?
  5. Mike Geepers

    Airbag compressor caught fire

    Hello forum, posted here mostly on my MC, hopefully i can get some help with this issue.....my friend has a 2003 silverado 1500 with airbags, and today we switched a bad compressor out. Sounds easy, and it was, until we aired up the tank and started hitting switches....and the compressor air...
  6. Mike Geepers

    Th200 to th350

    I have a th200 in my 78 mc and a th350 I want to swap out. 350 has a 6" tail shaft. Why is it longer than 200? Will I have to cut driveshaft? Any input be appreciated.
  7. Mike Geepers

    MONTE CARLO Need an edelbrock combo for sbc 305

    Swapping out the manifold on my mc 305, fairly stock, no smog, no vacuum lines....what is a good manifold/carb combo? Pic for reference

Please support GBodyForum Sponsors

Classic Truck Consoles Dixie Restoration Depot UMI Performance

Contact [email protected] for info on becoming a sponsor