Search results

Need a little help I am running Wilwood manual brake with the disc brake conversion on my 81 malibu. do anybody have pictures of their master cylinder and rear brake line. sorry if this question has been asked already

Need a little help installing the trunk strut bars on my 81 Malibu. I gladly appreciate all the help!

I think I’ll get rid of the wilwood proportioning valve and stick to the oem one

I have to figure out a better way to do it other using all those fittings

Where are you getting your signal for your aftermarket temperature gauge on your ls swap

I figured I could block off one of the front outlet and run I to the proportionate valve as well as the rear and from the proportionate valve to it original locations

How did you guys it. What didn't work?

Running that set-up mean I have a custom lines for front and rear

I have disc/ disc

I didn't wanna take it to the shop to have all new brake lines made so I figured I'd try to use the OEM as a distribution

Yes it's a combination valve. It don't rain much in Arizona I'll figure out how to adjust it when it get the car running

Am I able to use a disc/disc proportional valve as a distribution block with Wilwood combination proportioning valve.

I love the idea. If don't mind I'm going to use your setup Sent from my SM-G955U using Tapatalk

Did you buy one rod per side and then cut it half Sent from my SM-G955U using Tapatalk

It's been a while since I posted but I'm need of some help. I'm in process of welding my exhaust and not sure where or exhaust hanger to use. My 3" exhaust ends right before the differential and there's a lot of empty space between the gforce crossmember and rear section on the Malibu. Any...

Yes Sent from my SM-G955U using Tapatalk

Rebuilt tail light harnes gotta replace the far right bulb Sent from my SM-G955U using Tapatalk

I want to say 3 inch myself but wasn’t sure Sent from my iPhone using Tapatalk

I have a set of headers and need to know what size collector I need to buy and wasn’t sure if measuring the inside diameter is the right way to do it Sorry bout the fuzzy picture Sent from my iPhone using Tapatalk

Had to cut transmission and bang the header for it to work Sent from my iPhone using Tapatalk