Bonus points if you lift one front tire. 3 times unlocks 9 second mode!
1983 Oldsmobile Cutlass Supreme Sedan LS Turbo Build
- Thread starter GroceryGetter83
- Start date
Well the car definitely has a different look with these on it:
A little more aggressive than I would like, but they do look good. Rears should be here next week.
A little more aggressive than I would like, but they do look good. Rears should be here next week.
Wheels can always make such a huge difference, both good and bad. In your case good though
Weather finally cooperated for a minute!
Was about 88*F, humid and nasty. Didn't get a clean A to B pass but got a lot of data for improvements.
$54 uhaul ftw:
Tons of interest in the car:
Staging lane announcer asked if Grandma knew I stole her car:
Last pass I made; spun after the hit, let out of the throttle for a full second, jabbed it back down, let it eat:
Need some suspension work and adjust the boost ramp and I’ve got a real monster! 🤩
Was about 88*F, humid and nasty. Didn't get a clean A to B pass but got a lot of data for improvements.
$54 uhaul ftw:
Tons of interest in the car:
Staging lane announcer asked if Grandma knew I stole her car:
Last pass I made; spun after the hit, let out of the throttle for a full second, jabbed it back down, let it eat:
Need some suspension work and adjust the boost ramp and I’ve got a real monster! 🤩
Last edited:
Pulled the axles (35 spline beef cakes) to add the 3” wheel studs:
Easy job:
Looks serious:
Added 1/4” spacer for final clearance:
Next project is getting the rear pinion angle right; I think this is the source of my vibration at 60+ mph:
Going to order some adjustable upper control arms and get it right!
Easy job:
Looks serious:
Added 1/4” spacer for final clearance:
Next project is getting the rear pinion angle right; I think this is the source of my vibration at 60+ mph:
Going to order some adjustable upper control arms and get it right!
Last edited:
