9 inch brake line questions....

Status
Not open for further replies.

Northernregal

Sloppy McRodbender
Oct 24, 2017
3,359
12,826
113
Red Deer, Northern Montana territory
I mounted my T block in a Stockish location and bent hard lines close to the caliper mounts to tabs welded on the housing. I finished with 10" wilwood braided lines. I need to relocate the drivers side line more to the rear of the housing due to some contact with my exhaust tube. But otherwise it works perfectly.
20181221_132356.jpg
 
  • Like
Reactions: 2 users

pontiacgp

blank
Mar 31, 2006
29,270
20,391
113
Kitchener, Ontario
I mounted my T block in a Stockish location and bent hard lines close to the caliper mounts to tabs welded on the housing. I finished with 10" wilwood braided lines. I need to relocate the drivers side line more to the rear of the housing due to some contact with my exhaust tube. But otherwise it works perfectly.
View attachment 121603

I gotta question for you, how are you going to mount the pigtail springs on those spring perches?. :unsure:
 
  • Like
Reactions: 1 user

Northernregal

Sloppy McRodbender
Oct 24, 2017
3,359
12,826
113
Red Deer, Northern Montana territory
where did you get those spring perches, I was looking for the type you have but I could only find the ones that fit a 5" spring. I ended up using the spring perches I cut off the 8.2 to sit them on the middle of the tube
Quickperformance built the axle housing for me. They or Ballistic Fabrication have all kinds of goodies for driveline fabrication.
 
  • Like
Reactions: 2 users
Status
Not open for further replies.

GBodyForum is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to amazon.com. Amazon, the Amazon logo, AmazonSupply, and the AmazonSupply logo are trademarks of Amazon.com, Inc. or its affiliates.

Please support GBodyForum Sponsors

Classic Truck Consoles Dixie Restoration Depot UMI Performance

Contact [email protected] for info on becoming a sponsor