9 inch first pattern

[denny]

3:50 u.s. gear jegs case trac-loc. this is the initial gear pattern with .020 shim and .008 backlash. looks like it should go deeper. not very good lighting in the garage. what do you think?

 

[MC96]

Ring gear needs to go towards the pinion, loosen the rh lock 1/2 turn tighten the lh lock a half turn and re pattern

 

[pontiacgp]

what does the coast side look like?..

 

[denny]

what does the coast side look like?..

sorry bout that. here they are.

 

[Gonzo1970]

This is something I wish I knew how to do/how it worked.

Unfortunately, its going to end up being something I am going to have to pay someone to do.

-Gonz

 

[pontiacgp]

I don't know whow you are checking the pattern, I check for the pattern I turn the pinion forward and reverse with a little resistance on the crown. I think that gives a more accurate pattern

 

[pontiacgp]

This is something I wish I knew how to do/how it worked.

Unfortunately, its going to end up being something I am going to have to pay someone to do.

-Gonz

it's not that complicated, this video is pretty good at explaining....

 

[TURNA]

 

[denny]

I don't know whow you are checking the pattern, I check for the pattern I turn the pinion forward and reverse with a little resistance on the crown. I think that gives a more accurate pattern

i do the same

 

[denny]

i do the same

some of the directions i have seen say to put about 55 ft. lbs of turning resistance to get a good pattern read. i can't do that. this punkin is on my work bench. no way to get that much resistance in my garage.