Another 78 monte question about front lower A-arm bushings

Status
Not open for further replies.

Scott5982

Not-quite-so-new-guy
Sep 2, 2017
7
1
When installing an A-arm the front bushing fits snug in the bracket but the rear bushing has about a 1/4 gap in it. Basically,Is it supposed to have a gap in it and supported by the front or is there supposed to be spacers in the back bushing?
 

kalidromos13

Master Mechanic
Oct 12, 2016
363
63
Palmdale, CA
I had no such problems installing Lower A-arms in my 78. Both bushings were a tight fit front and back, but then again i went with aftermarket UMI lower A-arms. I dont think it should be loose, maybe the bracket is a little bent?
 
Status
Not open for further replies.

GBodyForum is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to amazon.com. Amazon, the Amazon logo, AmazonSupply, and the AmazonSupply logo are trademarks of Amazon.com, Inc. or its affiliates.

Please support GBodyForum Sponsors

Classic Truck Consoles Dixie Restoration Depot Mike's Montes P-S-T Southside Machine Performance UMI Performance

Contact Admin@GBodyForum.com for info on becoming a sponsor