Blazer brake?

Status
Not open for further replies.

Doug Chahoy

Comic Book Super Hero
Nov 21, 2016
2,564
2,661
113
I’ve got my UMI control arms installed with half inch taller upper ball joints on Blazer spindles. The spindles don’t want to move freely, infact they’re hard to move at all. According to the pics in the directions ca,s are on the correct sides. WHATS WRONG?
 

pontiacgp

blank
Mar 31, 2006
29,270
20,391
113
Kitchener, Ontario
I use low friction ball joints but the standard ball joints are very hard to rotate
 
  • Like
Reactions: 1 users

pontiacgp

blank
Mar 31, 2006
29,270
20,391
113
Kitchener, Ontario
make sure you grease the ball joints with some good quality grease. They are supposed to be greased from factory but I who knows if that was done properly and with what kind of grease.
 
  • Agree
Reactions: 1 user

Doug Chahoy

Comic Book Super Hero
Nov 21, 2016
2,564
2,661
113
I paid ALOT xtra for UMIs grease. I figure since I spent so much for the control arms, paying xtra for they’re grease is kinda like insurance
 
  • Like
Reactions: 1 user
Status
Not open for further replies.

GBodyForum is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to amazon.com. Amazon, the Amazon logo, AmazonSupply, and the AmazonSupply logo are trademarks of Amazon.com, Inc. or its affiliates.

Please support GBodyForum Sponsors

Classic Truck Consoles Dixie Restoration Depot UMI Performance

Contact [email protected] for info on becoming a sponsor