Bolt question

[Mark504nola]

Does anybody know of these are the same bolts where I circle red at ? And also what connect to this part where it circle green

 

[79 USA 1]

On my 88 SS the bolts in your picture in red are the same. The green circled brace runs to a threaded boss in the intake behind #3 intake port.

 

[Mark504nola]

On my 88 SS the bolts in your picture in red are the same. The green circled brace runs to a threaded boss in the intake behind #3 intake port.
View attachment 202569 View attachment 202570

I don’t even have that support that goes to the intake I guessing it won’t hurt anything

 

[383_StealthRam]

This is from 82-86 F Body Camaro, but should be similar. The bots you noted looked #2 in the illustration and call out as M12 x 1.75 x 35mm long.

Looks like the other bolt for the intake bracket is *not* metric though, see #4 3/8-16 x 7/8" long.

HTH!

 

[79 USA 1]

I don’t even have that support that goes to the intake I guessing it won’t hurt anything

Looking at your picture, where does the bar that runs out of the shot outlined in green attach to?
That is the support bar that goes to the intake manifold behind #3 intake runner.

 

[Mark504nola]

Looking at your picture, where does the bar that runs out of the shot outlined in green attach to?
That is the support bar that goes to the intake manifold behind #3 intake runner.

Looking at your picture, where does the bar that runs out of the shot outlined in green attach to?
That is the support bar that goes to the intake manifold behind #3 intake runner.

Anybody know where I can find the support bar online?

 

[carnutjw]

Anybody know where I can find the support bar online?

The bar you have outlined in green might be the right one, but just put on backwards. Try swapping it end for end. My SBC Performer intake has the boss and tapped hole for that bar, so it was important enough for Edelbrock to include it.
Orrr, is your picture with the outlines not your engine?