Factory gauge harness connector ???'s

Status
Not open for further replies.

dickeymoore

G-Body Guru
May 6, 2009
924
113
43
Atlanta,Georgia
What's the best way to connect to the wires on the factory gauge harness without cutting the wires I was thinking of something like the scotchlocks I don't want to cut the wires from the harness, I'm installing a dakota digital dash and are the wires 14 gauge?Thanks
 

fly_25

Greasemonkey
Oct 20, 2020
136
67
28
You could expose about 3/4" of the wire and solder in a "T" connection of some kind, then wrap it with electrical tape or so. I have done it that way in the past, I always try to solder where I can. For sure you would have to tape up the factory plug to prevent it from shorting out on anything.
 
Status
Not open for further replies.

GBodyForum is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to amazon.com. Amazon, the Amazon logo, AmazonSupply, and the AmazonSupply logo are trademarks of Amazon.com, Inc. or its affiliates.

Please support GBodyForum Sponsors

Classic Truck Consoles Dixie Restoration Depot UMI Performance

Contact [email protected] for info on becoming a sponsor