Having a tough time connecting my Moser housing with Ford 9 inch 3rd member to the driveshaft.
After pushing the driveshaft forward, need to come back 1.50+ inches to mate with the yoke. But the u joint ends seem to be too large for the yoke. Ends measure 1 1/8 diameter, yoke seems to be 1 inch diameter. The clamps also seem too small, both in diameter and length...can't get them in to start a thread on the backside.
What's wrong with this picture?
All my race buddies are at the track, without me, and the parts stores don't open for an hour and a half.
Anyone listening have an answer?
Raceoregon
1979 Malibu 383 stroker all the goodies, beefing up the rear end.
Thanks for any help!!
After pushing the driveshaft forward, need to come back 1.50+ inches to mate with the yoke. But the u joint ends seem to be too large for the yoke. Ends measure 1 1/8 diameter, yoke seems to be 1 inch diameter. The clamps also seem too small, both in diameter and length...can't get them in to start a thread on the backside.
What's wrong with this picture?
All my race buddies are at the track, without me, and the parts stores don't open for an hour and a half.
Anyone listening have an answer?
Raceoregon
1979 Malibu 383 stroker all the goodies, beefing up the rear end.
Thanks for any help!!