I have started to work on the pump to carb line with some copper nickle to make the bends easy & keep it clean looking. Then the OCD kicked in. I'm not getting the size of radius I want with the bends, making it all look out of place. I want tight sharp bends but my benders are not able to get as small I would like, don't want to use what ever round thing around & risk kinks or flat/crushed spots. So I've been searching Fleabay looking thru the trash listings to find quality AN fittings for my (non-existing) budget but not finding anything that gives me a warm fuzzy feeling. I've looked at the Earl's page, Summit, Jegs but not sure which to throw money at. Just need to go from point A to point B with the ability to swap between the 4175 & a Q-Jet but I feel like I'm over engineering it. So what are you guys using, mix/match between brands, meds to control the OCD, dotors to see...? All this for a pump gas street motor.