Is anyone running the Holley Hi-Ram in there build? I want to see if it will clear my cowl hood. I was trying to wait for Texas-Speed cast intake to be released but it taking too long.
Nope. I'm running the mid rise with a 3-1/2" cowl and there isn't much clearance. Definitely not enough room for the high rise. I can get a side pic when I get home.Is anyone running the Holley Hi-Ram in there build? I want to see if it will clear my cowl hood. I was trying to wait for Texas-Speed cast intake to be released but it taking too long.
View attachment 140975
Ok, thanks.Best pic I can find right now. The rear part of cowl isn't an issue, but the front is a different story. My hood is open underneath with no braces in the way.... View attachment 140976
Here ya go. From the front edge of the hood to the highest point on the intake is 23". Then from top edge of fender to top edge of intake is 2-1/2". That's roughly where you would need to measure your hood on the underside.
Also remember the hi ram is at least another inch taller, two actually if I recall. Hope this helps. View attachment 141081 View attachment 141082
Custom hood struts if that's what you mean? If you mean hood structure, it has a steel outer frame molded into the fiberglass.What is your hood bracket setup
GBodyForum is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to amazon.com. Amazon, the Amazon logo, AmazonSupply, and the AmazonSupply logo are trademarks of Amazon.com, Inc. or its affiliates.