Monte/Malibu/Camino console help

[Ribbedroof]

When i cut the console brackets out of my donor Monte last year, I made a nice little drawing of the location of them. However, I failed to note the reference point on the crossmember....which brings me to this question: can/will someone with a factory-installed console get me a measurement from the bottom lip of the dash at the base of the radio pod (the "wall" that surrounds it, if you will) to the front of the storage compartment with the lid open?

Trying to get all this stuff in place before the seats go back in, and would like for it to be where it's supposed to be, front to rear

Thanks!

 

[TURNA]

i have the section cut out in my garage i will get you a pic tomorrow

 

[gnvair]

This was some one elses picture. But this is the correct spacing for the rear bracket

 

[Ribbedroof]

Thanks guys!

I had a number, but didn't note if it was from the bottom or top of the crossmember

 

[gnvair]

I measured my 87 Grand National and found the rear bracket is the same as the Malibu/Monte/El Camino and in the same spot

 

[TURNA]

sorry just got in.

late night and going back in at midnight

i will get it for you in the morning

 

[Ribbedroof]

Turna, it is appreciated, but I think the pic posted above will get me there.

 

[TURNA]

 

[Ribbedroof]

.

Thanks TURNA, I can double check my drawing.

Man, they didn't spare the seam sealer there! The one I cut them out of didn't have any in those spots