Need mech pump to Edelbrock carb fuel line ideas

Status
Not open for further replies.

Michael Bennett

Greasemonkey
Jun 7, 2018
121
41
28
Looking for ideas on how to run fuel line from my mechanical fuel pump to my Edelbrock carb. I'd like to run a FPR as well. I have an 800 Edelbrock square bore carb and Edelbrock mechanical fuel pump. If anyone has pictures of their set ups with good fuel lines, regulator, and gauge it would be really helpful.
 

TURNA

Rocket Powered Basset Hound
Jul 24, 2009
10,941
19,990
113
Socialist NY
Get one of these screw a gauge into the port on the side and the regulator into the end add a filter and steel braid and your good


s-l1000.jpg
 

TURNA

Rocket Powered Basset Hound
Jul 24, 2009
10,941
19,990
113
Socialist NY
Edelbrock mechanical fuel pumps push 6psi so u shouldn't need a regulator
 
  • Agree
Reactions: 3 users

88ss408

Master Mechanic
Feb 25, 2007
281
34
28
baie st anne n.b
Unless he has the victor pump @ 10psi. The performer pump is 5.5 to 6.5 psi
 

Michael Bennett

Greasemonkey
Jun 7, 2018
121
41
28
I do have one of the lines like the top picture but the fitting from my carb leaks at the line so I need a new one. I do have the performer pump so I probably don't need the regulator. Just trying to figure out what bits and pieces I need to replace the rubber line with braided and AN fittings.
 

TURNA

Rocket Powered Basset Hound
Jul 24, 2009
10,941
19,990
113
Socialist NY

marz442

Greasemonkey
Jan 12, 2013
249
28
28
Cicero Il
Well you will prob need a right angle out of the pump. about 2 ft of hose a filter and fittings

Get one of these sewing tape measures if you are unsure how much you need or if you want to buy a premade line
.

Most dollar stores have them.

51wDHte0KQL.jpg


or just get something on this page

https://www.jegs.com/p/Edelbrock/Edelbrock-Carburetor-Single-Feed-Fuel-Line-Kits/751792/10002/-1
What size right angle fitting? I have a jegs fuel line and it doesn’t match up to the stock factory line!!! The jegs line has a 6an male end please help.
 

TURNA

Rocket Powered Basset Hound
Jul 24, 2009
10,941
19,990
113
Socialist NY
You will probably need a 3/8NPT male to -6 fitting female

But Im not sure since I have no idea what line or pump you have you have
 
  • Agree
Reactions: 1 user
Status
Not open for further replies.

GBodyForum is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to amazon.com. Amazon, the Amazon logo, AmazonSupply, and the AmazonSupply logo are trademarks of Amazon.com, Inc. or its affiliates.

Please support GBodyForum Sponsors

Classic Truck Consoles Dixie Restoration Depot UMI Performance

Contact [email protected] for info on becoming a sponsor