Rear axle swap out.

Status
Not open for further replies.

Jube455

Apprentice
Apr 30, 2018
88
67
18
Saskatchewan, Canada
I'm rebuilding a rear end for my 83 Cutlass with intentions of swapping it out. I'm also replacing all the suspension bushings and installing a blazer sway bar.
Any suggestions as to what else I should do while I have easy access to the underside?
 

UC645

Royal Smart Person
Apr 20, 2020
1,075
3,046
113
Kittanning, Pa
Go ham with an angle grinder with a wire brush, slap some rust converter on there and paint with oil based paint.
Couldn’t hurt to replace the rubber brake line with a braided one, either.
 
  • Like
Reactions: 1 user
Status
Not open for further replies.

GBodyForum is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to amazon.com. Amazon, the Amazon logo, AmazonSupply, and the AmazonSupply logo are trademarks of Amazon.com, Inc. or its affiliates.

Please support GBodyForum Sponsors

Classic Truck Consoles Dixie Restoration Depot UMI Performance

Contact [email protected] for info on becoming a sponsor