I have a question I was wondering if anyone could help me with. I just got finished installing a QP 9” I ran into an issue with the qa1 coil over shock mounting bracket. The qa1 install instructions say that the bolt for the lower shock should run through the factory hole of the lower control arm bracket and into the qa1 bracket to secure the bottom of the shock. The holes of the rear-end mount and the qa1 bracket do not match up. I took a picture of the brackets installed for reference. Has anyone ever ran into this before? Is the rear end mounts angled incorrectly? Do I have the wrong brackets? Or am I just dumb and set it up wrong? Lol Any help you can give me would be much appreciated!