Toggle sidebar

MONTE CARLO Where to drill hole for floor console shift

Status
Not open for further replies.
Rusty0015

Rusty0015

Not-quite-so-new-guy
Jan 22, 2022
24
22
3
Calgary Ab
Hi,

1986 Monte Carlo. Currently column shift. Want to change to floor shift. I'm hoping someone can direct me to info on where to drill the hole in the trans tunnel. Factory shifter, Factory placement. 200-4R. Thx
 
Last edited:
Status
Not open for further replies.

Similar threads

CrammerGram69
REGAL Where does one get parts for an 82-84 4-door?
Replies
3
Views
1K
Buick Regal / T-Type / Grand National / GNX
CrammerGram69
CrammerGram69
J
where do you guys run your mufflers? has anyone ran a varex?
Replies
1
Views
810
Exhaust
57 Handyman
5
J
4l80e where are you guys mounting the dip stick?
Replies
9
Views
2K
Transmission / Rear End / Driveline
565bbchevy
565bbchevy
schwim
EL CAMINO Code 53, where to start to narrow down issue?
Replies
13
Views
2K
Fuel / Air / Boost / Emissions
schwim
schwim

GBodyForum is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to amazon.com. Amazon, the Amazon logo, AmazonSupply, and the AmazonSupply logo are trademarks of Amazon.com, Inc. or its affiliates.

Please support GBodyForum Sponsors

Classic Truck Consoles Dixie Restoration Depot UMI Performance

Contact [email protected] for info on becoming a sponsor

Top Bottom