Recent content by houston_t

You may be looking at the wrong kit. The part #s I was told by Vintage air for the 82-88 are 964332 & 964333, believe he said the 333 has a larger blower motor and housing. Both are built to order and the turnaround time is about 2 weeks.

Did you ever find out if the 82-88 vintage air kit will work ? I want to do the same with my 79 Monte ( factory non ac car ) vintage air tech wasn’t a lot of help

Where can I find new chrome bumper trim like In the pic below ? The thin strips above and below the marker light

Holley setup tune

My LS1/4l60E swap seems a little underpowered and I’m guessing it has to due with my tune. I’m new to the terminator and need some help with the fuel and timing tables if anyone can assist. I know I can send it out for a remote tune which I may do at some point but I would like to have it...

Finally got some spokes and vogues. Been considering it for a few years now on different cars of mines.

I went with powerstop z23 still waiting on them to arrive and had my factory rotors turned. They only have about 36k miles on them so there is plenty of material left.

I just did the rear brakes on my 79 and noticed I had those leftover too along with oval rubber plugs I am assuming were for the shoe adjusters. New new backing plates did not have a knockout in them for it.

My current pads give off way too much brake dust I’m not sure what they are but I have purchased the so called upgraded ceramic pads before from the auto parts store and they weren’t great either. What’s a good set of pads that will give off low brake dust ? Car is not performance oriented the...

I was looking at the chassis saver earlier, think I used it on a cutlass back in the day can’t remember. Anyway think I may just order a gallon of it doubt it will go to waste between me and my friends cars.

Just wondering if 1 quart would be enough to do the underside of a g body if anyone has any experience with it or something similar.

You should start a separate thread but check out gbodyparts.com

Yea I’m not looking for a 100% match, my b pillars are faded hard on the upper portion plus I’m looking to add kick panels from a computer car so I can put my Holley computer behind the pass side. The door panels match up nice so I’ll be happy if the rest looks the same, for a complete match I’d...

Yea I def planed on buying something from harbor freight if I did.

I have seen those at painters supply and never thought of that. I did some more reading on Dixie’s web site and just realized it said the pint is a custom mixed color and the spray can is not but it’s close to the factory color. I have the lower door panels with the speaker cutouts and had them...