Recent content by slowmoving1

alot of tuning and time. i hope it gets there thanks

bbc 60 over 13:1 compression forged crank rods pistons 990 rect port heads fully ported super victor intake 1050 carb super comp headers small cam [email protected] int [email protected] ex 600,620 lift head studs,1071 mls gaskets transmission powerglide with brake 4500 stall 8.8 ford rear fully...

motor 454 bbc .060 over 13:1 compression, all forged bottom end set up for the blue bottle, stock 990 heads fully ported and polished cam is 600 in 266 dur @.50 .620 ex 276 [email protected] solid flat tappet,roller rockers, super victor intake 1050 dominator, power glide by select...

moser 33 spline axles,moser spool, if i went to 35 spline i would have to change 8.8 housing end to big ford stuffand that = pain in the but

can i see some pics of your set up? sounds like something i need to look into before i build my anti roll bar thanks what does the 468 run in your sig looks nice

have to weld spring pad as well as lower control arm brackets. axles are easy just get 5 lug mustang pattren from 79-93 and check backspacing your there.{ps 87-93 stang is factory 4 lug] i feel this is a easy swap just take your time and have some friends come help

using 4 lug for now. will get 5 lug drilled later for nhra specs you need adj uppers for the 8.8 swap, stock uppers will not work due to pinion angles and so forth the pinion angles is set at -2 deg for hard hit of the t-brake 1/4 inch diffrence in rear not enough to worry about because...

just finished my 8.8 install install check my post

well i heard it would work and it does. started with 8.8 mustang rear out of 92. 33 spline axles,spool, c-clip elemintor, 410 gears removed old ford brackets from 8.8 removed old 7.5 pos meaured old brackets from 7.5 took a long time to make sure i did not damage brackets and spring...