Search results

crossmember If you want one cheep go to the junk Yard and find a G-Body. Or you can go online and find an after market for about $180

heads you can run the 305's but i would go with the vortect

seats get a nut remover it will cut the nut off but won't damage the studs find out what size the stud is and run a die over it to clean the threads up and buy a new nut

won't start I Had the same problem with my 350 I had the distibuter 180 degrees off pull the dist. pull the number 1 plug if you don't have pressure gauge stick your finger over the plug hole and have someone turn the engine over until the pressure build up and it pops your finger out of the...

thermostat I was told at the machine shop not to run a thermostat during the break in period

Carbs It's hard get the best out of both My exsperience with the Q-Jet is it get a lot better fuel mileage but little performence. I have a 4 barrel holley on my 84 ss monte now it is good for performence but i can only get about 220 miles on 18 gal. If you want both performence and fuel...

stolen put a battery kill switch, but a wheel boot, there are alot of good suggestion on here

Brackets I Had to cut part of my bracket to make it work with my headers and you will have to use a spacer a small peice of pipe work very well find a peice that the bolt will just pass through and you might have to get a longer bolt but make sure its a grade 8

gm g-body sending unit o empty- 90 full