Recent content by Mistermastamind

84 Regal 24x9 front/24x10 rear Can someone who has their build sheet from purchasing NEW wheels please tell me their front and rear offsets. Thank you in advance.

Yes, Yes, Yes, this is why I love this site. Thank you so much fellow G-Body owners. Everyone's advice will be used.

Chrome oil pan with "Mr Gasket" one piece oil pan gasket continues to leak. Should I go back to the multi piece gasket or is there some type of sealant that can be used once the one piece gasket is replaced?

I am delighted to see that my engine is such a hot topic. Give me one indication that makes you think that my engine is not 500 horsepower and I'll prove it to you.

Hey check out these Superlift Coil Springs. Superlift makes coil springs to lift your G-body from 2" all the way up to 12". Front->http://www.partstrain.com/store/details/Superlift/Coil_Springs/S30550.html?location=Front...

Re: Char-Broiled Aluminum Pistons after just 2500 Miles... W The workings of my old mechanic. SMH @ him. He lost a very good customer in me. He stated that the single electric fan wasn't keeping the car cool enough, so he installed the mechanical fan also. With both fans, the engine temp has...

Please help. I am in need of all new exterior chrome trim for my 1984 Cutlass Supreme before going to the body shop. Below is a link to the picture examples of what I am in need of, though I basically need every single exterior chrome trim piece including the trim that goes around all (4) wheel...

Re: Char-Broiled Aluminum Pistons after just 2500 Miles... W Ok thanks for everyone's input. It seems that my old mechanic did not know what he was talking about. The 600 cfm carb turned out to be the exact carb I needed for my set up. In fact, my old mechanic never had the timing set...

Small Block Chevy 350 bored .40 over 11:1 Compression 500 HP

I'm guessing you have to enter the trunk through your back seat and chain it closed that way. :?

Hey my boys back in Detroit Chain their trunks closed so if anyone does get in the trunk, the trunk only opens about 6 inches. :twisted:

I had the same problem. Buy everything you need from a 1985 Chevy Monte Carlo. Frame Mounts, Engine Mounts, Etc.

Re: Char-Broiled Aluminum Pistons after just 2500 Miles... W I made a mistake in my introduction and posted the same pics of the passenger side of my engine. Here is a pic of the Driver side.

Re: Char-Broiled Aluminum Pistons after just 2500 Miles... W My mechanic has mentioned to me that the 600 CFM carburetor was not big enough for my set up. I am currently having a 750 CFM rebuilt. He says that the Compression may be 10.5 or 11 to 1. He stated that with the 600CFM my engine was...