Recent content by nawlins-tim

The New booster came with a pin installed. Im sure of that cuz I measured and referenced it to the old booster pin. Might be the Master cylinder since its the one that has been on the car for years.

Well we might be getting somewhere. I have an aluminum master cylinder but it seems straight bore. I have to take a closer look on that. I read that the early master will fit on early AND late booster. But not the other way around. ( later master wont fit the early booster) I bought a early...

I did the master cylinder bleeding on the bench. Its got me pissed forvsure. There IS a difference in 79-80 boosters and 81-86 boosters. They have different part numbers. Same goes for the master cylinders. Got to dig in this weekend. Thanks

All the gbodys I ve seen the brake rod and booster pin are NON-adjustable.

I basically just changed the booster. Maybe Its the wrong one. Maybe its the correct booster but its defective. Ill keep at it. This comming weekend I will have to pull it back apart and take a CLOSE look.

I did the correct bleeding procedure. And i did measure the New booster, which seemed to be identical to the one I removed. The new booster had a pushrod in place which seemed to be like the old booster. And the problem im seeing is the pedal is not in the same position at rest as previously...

I changed my brake booster the other day on my 1980 Wagon . I used a master cylinder that was on my old brake booster. Now, after bleeding the brakes and getting ready to take a test ride, I noticed the brake pedal is a half an inch away from the brake light switch. For some reason the Travel is...

No I cant speak for fitment of channel on the Back windows. I only bought one piece to try, and I used about 90%of it on the driver side front only. And the upright area of the front side window was a funky shape. The CRL product close enough in that area for me. The front area and top run...

If I was ANYWHERE close I would not hesitate to grab that rearend. Too bad Im in New Orleans

The upright area was a little tricky. The CRL product fits but not like oem. I just made the whole run in one piece. It took a little trimming in the 90* turn to make it lay flat. Today I decided to put my door panel back on without gluing the channels . They are holding fine for now. Actually...

UPDATE on window channel.. I contacted CRL laurnce . First I asked them how to obtain an account. They replied with some login details and I ordered the window channel linning listed above in this thread. They are much longer than needed and not formed for the corners in the wagon window frame...

When I made mine I used the compression type. Neither solder nor crimp. Check 'em outhttps://remybattery.com/cable-connectors/connectors/compression/lugs/4-gauge-compression-lug-connector.html#347=

look around on facebook at some of the Gbody wagon pages. I saw a set recently , but they are not cheap.

Im sending you a PM

Well maybe I can try them for science. I am currently being "reviewed" by the log in Nazis. So if I get cleared I'll let the forum know the prices. ALSO in the application process they asked if I plan to resell their products, I said no of coarse