Toggle sidebar

Sealing strips?

RICKDIZZLE

RICKDIZZLE

Master Mechanic
Sep 16, 2014
293
275
63
Ok after what seems like forever ago, I plan to replace my B pillar chrome trim this week. I have my old thread here and understand the process...just not sure of what to use as a sealing strip on the seal to make sure it's water tight again.

Original thread for reference. P.s. it's closed thus the repost:

1985 Cutlass B pillar trim removal

Can anyone walk me through how to remove the B pillar trim...the wide piece that is on the front of the B pillar. I wanna know if I can do it and replace with a new one without tearing up my paint or drip rail? Any help, ideas or pics?
gbodyforum.com gbodyforum.com
 
I just used some closed cell weatherstripping that’s used for truck camper tops on mine.
 
  • Like
Reactions: 1 user
I'm having a hard time getting my head wrapped around "sealing strip on the seal".

Are you talking about the foam seal that attaches to the back of the OEM B-pillar plate and weatherstripping channel? GM plates came with it installed and used it as a moisture seal so water wouldn't work itself behind the trim or channel.

Amazon has some. Look for around 1/16" thick closed cell. The peel and stick is likely the best since you don't have to mess around with glue. Fairly cheap and you can redo the entire car!

 
  • Like
Reactions: 7 users
69hurstolds said:
I'm having a hard time getting my head wrapped around "sealing strip on the seal".

Are you talking about the foam seal that attaches to the back of the OEM B-pillar plate and weatherstripping channel? GM plates came with it installed and used it as a moisture seal so water wouldn't work itself behind the trim or channel.

Amazon has some. Look for around 1/16" thick closed cell. The peel and stick is likely the best since you don't have to mess around with glue. Fairly cheap and you can redo the entire car!

Click to expand...
Thank you!
Yeah this is what I was referring too. I apologize if I wasn't clear.
1000007650.jpg
 
  • Like
Reactions: 1 user
It's closed cell camper top tape. Be sure to copy the factory pattern. You may also need butry rubber in the corners. My Regal has that.
 
  • Like
Reactions: 1 users
Try the 1/16" thick junk, 3/32" at most. If you get the fat stuff you'll cry.
 
  • Like
Reactions: 2 users
You must log in or register to reply here.

Similar threads

john87442
What seals do you recommend
Replies
4
Views
746
General Discussion
john87442
john87442
69hurstolds
    • Like
Never Too Old To Learn- Seal That Solenoid
Replies
2
Views
620
Electrical / Ignition / Starting
69hurstolds
69hurstolds
Clone TIE Pilot
PC seals for SBC exhaust valves
Replies
11
Views
1K
Engine / Swaps / Driveability
87 Monte Carlo SS
8
W
    • Like
Fresh Air Door Seal Issue
Replies
7
Views
1K
Cooling / Heating / AC
86 Salon
8

GBodyForum is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to amazon.com. Amazon, the Amazon logo, AmazonSupply, and the AmazonSupply logo are trademarks of Amazon.com, Inc. or its affiliates.

Please support GBodyForum Sponsors

Classic Truck Consoles Dixie Restoration Depot UMI Performance

Contact [email protected] for info on becoming a sponsor

Top Bottom