I am switching to a 307 in my 85 Cutlass, because the old engine and transmission had called it quits. I need to know where I bolt the K member engine mount pads. I have seen the picture of where the SBC mount pads go. If anybody has a picture of it I would appreciate it. I am only switching to the 307 because it was cheap with low miles (44K), and a th350. I eventually want to put a Vortec headed 400 SBC in it.
Buick v6 to Olds 307 swap
- Thread starter al_cohighlic
- Start date
- Status
Well, you are going from worse to bad, instead of the other way around. Anyhow, they pretty much will only bolt in one way, if I am not mistaken. Just line em up and there you go! You'll have a slightly less slow Cutlass!
im sure you can find a 350 chevy dude.... find a smog chevy engine... then take your 307 and put them on the 350..it should hopefully raise compression.... with small valves and high compression you have a torquey fun street machine.
its as hard as switching the frame pads.. beeter saying something like get a chevy is sort of depressing. i vote put an olds in an olds!
- Status
