can someone post tut

[aaron_hollis5]

plz....can someone post a tut on removing rocker moldings from door and rear quarter panels with pics? thanks in advance

 

[Coveted]

I dont have pics, on the fender just take the screws out and pull em off (might need a screw driver to pry)
same goes on the door.

 

[pokertramp]

The ones on the doors are on plastic clips. I took off both nuts, front and back of door, and then I just pulled them off. There are screws all along the bottom that might be a b*tch to get off, a grinder comes in handy. I take it that you don't plan on reusing them? they will cause rust and junk builds up behind them, it did for me so I sold them.

 

[3XBrownCutty]

there is two nuts on the opposite sides of each door, remove those, and just lift up the whole chrome piece, and it will come off the plastic clips. removing the clips is very straight-forward.

for the rear, you have to take out the bottom screw on the back of the wheel well chrome, and again lift up, until the chrome is off of the plastic.

overall pretty straightforward, again 😀

 

[aaron_hollis5]

nah i dont plan on using them after i take em off....wanna remove em since im missing the ones on the front quarters on both sides...but thanks everyone...