Injectors

[Dylan88]

Anyone try these drop in 72 lb Delphi injectors ? Will be getting car ready for boost ( boost cam kit, etc) and looking at these from Texas speed.
Just curious thanks for any advice. Link below of them.

Fuel Injector Connection 72-lb Delphi Drop-in for 99-07 GM Trucks/SUV

FICB72T Fuel Injector Connection 72-lb Delphi Drop-in for 99-07 GM Trucks/SUV

www.texas-speed.com

 

[Streetbu]

Why not these?

SEP - Gen IV "Flex Fuel/ EV14" Truck Style - EV6 (USCAR) plug - 850cc/

Snake Eater Fuel Injector with Jetronic Connector 850cc Siemens Deka Style Body.Dynamic Flow Rate: 18.6 mg/pulse 2.5ms PW, 20 ms PeriodCoil Resistance: 12 Ohms (This high-impedance injector designed for use with factory ECM/Injector drivers)Connector: JetronicRing Type: VitonDesigned for high...

www.snakeeaterperformance.com

 

[64nailhead]

Never used them, but FIC doesn't make any junk. My only question is why so small? 72lb's are going to be all done by 600-700 HP.

 

[Dylan88]

Yeah dont think ill be over 700 any time soon.

 

[Dylan88]

yeah could look into those too thanks !

 

[64nailhead]

Yeah dont think ill be over 700 any time soon.

700 crank HP is about 600 whp, and 600 crank HP is about 500whp, unless you're using a dinky *ss turbo, you'll be at 600 crank before you can say boo.

What is your setup, i.e, motor, turbo, cam, trans, rear?

 

[Dylan88]

5.3 lm7 , bald eagle boost cam (all new lifters pushrods springs etc) , 2800 stall, th350, and has 373 gears. those 80lb snake lots?

 

[Streetbu]

Yeah, you'll be around/over 800 crank if you use E85 with the that combo...