Lots of questions 87 cutlass with sbc turbo 350

[bryguy39]

first off, i have no dash lights? my fuse is good but no dash lights?


my park option on the colum is touchy its like it dont have its own notch, so can bump in reverse with ease 🙁


also how do you get the gauge cluster out of these cars as im going to pull the check engine bulb.

also i have the 3 gauge pod with gauges in my car and has anyone else had difficulties with this looking right?

all help is appreciated. thanks, Bryan

 

[bryguy39]

anybody???

 

[bryguy39]

anybody???

 

[Blake442]

first off, i have no dash lights? my fuse is good but no dash lights?

Could be as simple as your dimmer switch being turned down, or burned out bulbs, or a missing ground.

my park option on the colum is touchy its like it dont have its own notch, so can bump in reverse with ease 🙁

Your linkage from the column to the trans probably needs adjusting.

also how do you get the gauge cluster out of these cars as im going to pull the check engine bulb.

Remove the dash cluster surround, un bolt the cluster, pull it out a bit, disconnect the speedo cable and vss if your car has that.

also i have the 3 gauge pod with gauges in my car and has anyone else had difficulties with this looking right?

? Do you mean an aftermarket gauge set up?

all help is appreciated. thanks, Bryan

Hope that helps.

 

[bryguy39]

How do i adjust the linkage? also yes im running autometer gauges on my A-piller. also do i have to take the whole dash part off to get to the cluster?thanks,Bryan

 

[Blake442]

How do i adjust the linkage? also yes im running autometer gauges on my A-piller. also do i have to take the whole dash part off to get to the cluster?thanks,Bryan

Linkage can be adjusted where it bolts together.
You just need to remove the dash section that surrounds the cluster.
Don't know about your A-pillar gauges...