New Headers

[D's350GP]

just traded a guy my rusty camaro headers for a set of long tubes

 

[Chevyman85]

Nice, are those going on your GP? Good luck fitting them in. The pass. side is a bit tight! :?

 

[D's350GP]

yeah, i checked at Summit for headers made for g-bodies, and they look about the same. But i expect them to be a BI&$H to put on :x

 

[KevinB]

yeah, i checked at Summit for headers made for g-bodies, and they look about the same. But i expect them to be a BI&$H to put on :x

I just put some on my sbc in my Cutlass. Not bad at all. A few of the bolts are hard to get to (the back one by the a/c box is the worst). I had to install the headers into place from the bottom of the car. I could not get them to go into place from above.

Good luck with them.

 

[Chevyman85]

Yeah, the only way I could fit my full length headers in was from underneath. It was really tough to get that last #8 exhaust bolt. But good luck, I still had a tough time with it.

 

[78mali350]

agreed with all the passenger side was the hardest but if you go in from the bottom it should work without problems