Recent content by Curlz

All good, someone before me sealed it down with silicone. Some WD40 disolved the clue and she came right out.

That bottom clip almost has me beat, I have what looks like two tabs at the bottom. Do I push those down? I have been trying but no luck, is there a special trick?

Oh perfect, yah I see it thanks!

Hey Guys, I am in the middle of changing my heater core on my 81' malibu without air. The old one leaks, wont hold 5 psi with from a pressure test. Long story short, I have the old one exposed, the one clamp screw off and ground clamp, but it seems like I'm missing a screw somewhere. It wiggles...

That's perfect, that's exactly what I was looking for.

Hey Guys, I have been offered a gauge cluster from an 85 monte carlo column shift. I have an 81 malibu column shift and I am wondering how difficult the switch is, not from a "will it fit?" but more is the harness the same? My malibu has just the idiot lights (Right), and the monte carlo has...

No, I have detents in the column as well. I know the detent is in the trans, but the column has preset detents to where it thinks the shifter will be. It's not like the trucks where they rely on the trans detent.

Really? No replies? Anyways swap complete, the linkage fits just fine. The column shifter travels through P-R-N-OD-D-2-1 without any modifications or issues.

I'm about a week away from swapping the 2004r in place of my TH350 into my 81 malibu . It's a column shift car and I want to keep it that way (Love the bench seat).I got the crossmember and frame extension, drive shaft etc. I am more concerned about the stock column shift linkage. Obviously I...

I've read up on the headers, looking at the hooker big block swap headers. Any experience? Can they be installed with the engine in?

I had a bad fuel pump, and it would loose it's prime, all the fuel pumped up would bleed back into the tank. I would constantly have to pump up the line until i found the problem and changed the pump.

What rad are you running? Was there any mods that were needed? I want to try and stick with a clutch fan if possible.

That looks mint! Thanks for the info, did you have to do anything fancy with your engine mounts?

Thanks for the info, my 454 doesn't have provisions for a mechanical pump. So i'm going to be running an electric for sure. When I bought the car I did all new suspension parts at all four corners. I always new I'd put a rat in it so i went with Raybestos heavy duty front designed for big block...

I was in my local pick and pull and I stumbled upon this in a 1998 3/4 ton truck. I pulled it for a whopping $220+tax(too good to pass up). I plan on putting this in my malibu. It's a 1998 vortec 454, 4 bolt mains. Anyone have any experience with them in the g's? I plan on putting some kind of...