Ok the only other thing I can think of the the bushings in the rear trailing arms. I've replaced a couple they looked smashed. You can see them if you look closely. The cops around here complained that it would feel like it wanted to switch lanes on acceleration when chasing down cars. I've...
Yes I bet it happens when you are floored and it goes to 2nd gear. Or if you let off right before it shifts. The programming the the pcm of the p71 raised shift point couple hundred rpms. The noise tlyou here is most likely the belt chirping. Mine did it all the time. A new belt and tensioner...
Here in Florida the cop cars with the 3.27 gears were mostly supervisor cars. And a lot better condition. I used to have a 99 we built the motor put a converter in it and sprayed 150 dry shot all the time.
I know those cars upside down and inside out. If you have any questions I'd be happy to help. Biggest problems with the 03 is cooling fans and fan controllers. Btw with slight trimming and a Cutty plate it fits perfect in a g-body. They are bad about axle shafts going bad and they leak gear...
I heard of a guy here in town selling a big block GN so I went to look at it. The paint is black and is about 6 months old. It has a supposed 454 And th400 trans. it looks like an old build and its been sitting a few years. I could not here it run at the time because of a bad starter they said...
the 4 gauges off to the side on my 88 fuel oil temp and volts in the morning when its cooler dont work. in the afternoon they are fine. i took the cluster out and cleaned the circuit board where the connectors go in i cleaned the wires and even spread them a little. now when they dont work...
where can i get a good fuel sending unit that wont break the bank. 2 years ago i went with a spectre, i wasn't impressed with quality, but it lasted for 2 years. i have removed all emissions and charcoal canister. i was using the 3 port sending unit and just plugged other 2 ports. fueling up was...
ill enter this month. not pretty yet but im workin on that. my 87 ss I bought 7 years ago for $500 no motor no trans no interior no ss specifics on front. entire front clip minus ss stuff and the doors were in a pile beside the car. i put the front together and found a Pontiac motor and trans...
I have 3 sets. headman shorties I modified the collector. doesn't flow very good I also have headman long tubes they are a 3 tube design and only had to modify 2 tubes on driver side. they are ok but I called mark at maddog headers. they have 4 1-3/4 tubes and are long tubes they are very nice...
my crank pulley wouldn't work with a regular pioneer or professional products I had to go with the sfi professional products. then I had to use 2 of the plates from stock balancers for my march pulley to line up. dunno if you will have to do this too.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.