A lot will depend on welding skills, not necessarily body work skills. Are you planning to butt weld it so you can't tell a repair was made or lap weld? I usually wind up making things worse trying to butt weld. Especially thin sheet metal where I cant get a backing spoon or something to help...
I looked at Bailey and Delteq years ago when I started the swap, I know Delteq had shut down and thought Bailey had too. I want to use the 411 pcm because I can't find anyone locally to tune it and I can't pull any trouble codes with my current 95 LT1 pcm. That's why I'm looking at torqhead for...
Hi all,
Looking for opinions on what to do with my 86 Monte Carlo SS. It currently has a 95 LT1 with a 4L60E. I'm not happy with the lack of diagnostic and tuning capability with the current computer and the inherent opti-spark problems (been stranded on the side off the road in two different...
I'll be watching this closely, I'm currentl dealing with the same situation. My prop valve tool just showed up today, still waiting on a couple other parts and I won't be able to try rebleeding until the weekend or early next week. :popcorn:
It's not just the shipping cost with Jeg's any more for me. Ordered a sub-frame from them around the first of Dec because they were the lowest price at the time. A couple of days later the manufacturer lowered their price below Jeg's and everyone else followed, so I asked if they would price...
If the color doesn't matter, I've had good luck using 3M Rigid parts repair and SEM problem plastics repair on the plastic cladding on my Syclone, the 3M is blue and the SEM is tan. The 3M is available in 5oz tubes that you mix like JB weld, I believe the SEM only comes in cartridges. I had to...
2 is the electronic spark control module, 3 is the manifold absolute pressure sensor and 1 looks like a relay. If your planning to go old school with a carb and simple vacuum distributor you can delete the ECM and wiring.
With the Caprice switches you just turn the joystick itself, to the left for drivers side and right for passenger side. I'm getting ready to do this myself but plan on using two separate switches in the factory locations. (armrest and dash bezel)
After moving into the new house almost a year ago, I'm finally getting around to running the air lines from the compressor up to the garage. Today I mounted an after cooler on the back of the belt guard and built a water separator that I'll plumb in after the cooler and before the tank. Still...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.