Recent content by yennchi45

Thanks a lot for that information. And sure I’ll take some! If you already have the right ones and saves me from searching for them why not, long as the shipping is not too much!

If you remember the size please let me know I’m missing the retainer and it keeps moving

What size nuts?

Thanks will try that later today when I get some contact cleaner.

Quick results! So after rigging up a test ground wire to the light housing my map light now turns on and off with the little switch, but you have to wiggle the switch and get it in just the right spot. So my original suspicion was both correct faulty switch and bad ground! New question is can...

Ok thanks about to try it now!

In attempt to rule out bad ground can I just run a ground to the housing or would that be bad?

Thanks guys that is what I thought. Guess my little switch is bad or it is not grounded good enough

Hey all I have a question about the dome light with map light. It has a little switch on it and I’m wondering which light does the switch operate? Is it for the map light only or do they both work together? Does both bulbs supposed to light up when the doors open or only one?

And that is an alternator for a 2004 Tahoe!

When I did my serpentine setup a few years ago I used the brackets, evaporator, condenser and water pump for a 1993 firebird. And I purchased new lines for a 1982 cutlass. Have had no problems everything lined up great!

Where can I find a driver side door handle

Metal work should be minimal to nun like I posted earlier this was done years ago with the thought in mine of going back original. The hardest work will probably be getting the dub emblem off that covers the hole

Do you have the outside handles and rod to the latch?