Search results

Yes, from the front side first....If u need to make any small to medium repairs clean with a wire wheel from harbor freight that comes in the variety pack....oil base rustoleom from walmart protect well against rust ...dont use the aerosol can , use the paint can....and a brasing rod is great...

Lucky ques. I'm repairing my plates now . They have 2 inch wide 3m tape in the center and across the front side ledge there are about 1.5"x 1/4 "tabs bent at about 130 degrees angle . They insert in the header panel. The basic door panel removal tool is great for this ( the long handle bent fork...

Thanks alot for the info.

Will adding 1.7 rockers to an 1976 olds 445 help , hurt , or remain the same as to performance. ?

2.73s- 3.23s is keeping mpg in mind but if u go up past 3.23s to 3.42s that should be easing up on performance and decreases mpg , if ur not hotrodding but only crusin with a small block then ur org. Gears is what u need

Does any one know why u get the no valid form token error , While trying to make changes in your photo gallery.

Thanks guys very much ... what pistons would be a better choice without breaking the bank..

Hey guys do anyone know the true hp rating of a 1976 olds 455 engine stock .....also is this year engine desired as well as some of the earlier versions of the 455..

U can do it yourself ....If needed I can guide u in the that I did mine

Vicksburg ms

Dont be scared doit but take all the donor t-top peices u can find such as interior trim and pillar trim ...it took me 2hrs to complete mine ....but i premeasured 30 times and rethought it 100 times but it was a sucess but my cuts did not cause any allignment issues and they were diff. than...

I have 88 cutlass that I'm planning to install a 455 with a 4speed standard behind it ... but when it comes to the rear end I want dependable highway gears and I want to know can I just use a spool in my stock 2 point series ratio gear rear end to hold up behind my engine ... not for racing but...

I'm trying to make it dependable but also a low budget build...I don't know exactly which ratio but I'm sure I have 2. Somethings gears but how would a spool in the rearend hold up with the stock rear end

I have a 1976 Olds 455 that has a automatic flywheel....but I'm wondering later will I be able to bolt up a standard flywheel with no issues to my current crankshaft I'll b using a 4 speed muncie, and a bop to Chevy bellhousing adapter plate ..understanding that I may have to shave away a Lil of...

Hey guys I have a 455 with a 4 speed manual behind it..I was wondering what is the best rear end swap for the car..Im planning on some highway use

Thanks

Hey guys I would like to know what would be the outcome if I installed a Saginaw 3 speed behind my 1976 Olds 455 engine in my 88 cutlass supreme. Would it hold up ? My standard options are slim for now...

Hey!! First off the car looks great....hands down but what rim and tire setup did u use and how long did it take to u to install the bags? And last how good of ride do you have