Recent content by 454cutlass

My new ones for the cutty. vision sport mag

Heres mine on 83 cutty didnt have the holes on the fire wall. Fit very well.

I used b body upgrade with ub machine upper control arms to correct the geometry. Old design but a good one

275/50r15 ets on 15x8 4.5 bs. Had to use a small spacer to give some clearance between side wall and frame

Marker lights and coat hangers from gbody parts

A little bit expensive... not too bad thought. Soo much better than the bench i had

They look like f body rims. They will fit. I belive you have to use the ones marked front on the back of the g body and the rear on the front. Belive it is due to backspaceing

Bought a summit racing / g force one. Bought it when i went from bop th350 to 200r4. No problems other than being an 83 and needing the weird little extension piece. Did do all new body mounts the previous year.

Started installing new pypes xpipe with dumps. Not bad fitment

Have had a quick performance 9" for years no issues. Dont remember off hand exactly what umi uppers and lower i have. Know they have roto joints. Dont have any pucs of uppers or lowers

These are the sliders http://corbeau.com/oldsmobile-cutlass-oem-bench-73-77-seat-brackets.html The bench to bucket conversion http://www.gbodyparts.com/product_info.php?cPath=55_84_89&products_id=769

Also installed tilt column and new steering wheel

Starting to work on the project again. Took out carpet and head liner. Dumping the bench to go with buckets. Haveing a friend weld in the new brackets

Thought about it but required to much work. This is a pic of a 3.8 with a gen 5 blower. In a regal 98 i belive.

Just removed a bench seat from an 83 cutlass