Recent content by dave_s1987

thanks for the advice. I don't remember removing any computer when I removed the old setup and installed the new drive line. I never worked on cars or knew anything before I started this project so I basically just ripped everything out and replaced it.. i'm thinking there was never a computer...

I ended up rolling my car into the garage and I'm getting ready to head off to work. I'll check the dipstick and plugs tomorrow. I'm hoping you're right about the gaskets and it's just something else. I have only gotten about .5 km driving since it was broken in and it has only really ever...

I ended up rolling my car into the garage and I'm getting ready to head off to work. I'll check the dipstick and plugs tomorrow. I'm hoping you're right about the gaskets and it's just something else. I have only gotten about .5 km driving since it was broken in and it has only really ever...

I have a 200r4. I did slightly over fill the trans when I topped it up..

Would a blown head gasket cause a car to stall on have a lot of trouble starting back up? Or is that another issues all together?

People keep asking me that but I have a terrible sense of smell. I'm always working alone so I have no one to ask. Does it smell sweet people ask? Well it definitely doesn't smell like candy is shooting out if my exhaust lol if I had to put money on thiugh I would say it does smell a little...

Hey guys just though finish this thread of lf with a few a couple questions. I still can't seem to get my car to run. Installed the fuel regulator and carb spacer as well as a working spare carb and the car seem to run and fire up really good. Today I decided I would test drive it now that I...

Also what is strange is that now and it started and ran fine. I heard that knocking sound but decided I would put it in gear and take it around my block quickly and it seemed to run fine. The knocking sound got quieter but did not go away. What is strange is that when I got home from my 2 min...

I hope it's not washed out rings. If it ends up being something serious it's probably going to be the end of my project. I have thousands and thousands of dollars invested now so that would be a real blow. Keep your fingers crossed for me lol

I'm going to jack it up and take a look at those later on today. I hope that is where my problem is an it's not something more serious

I checked the oil dipstick and it didn't seem to have any gas on it.. what would be the best way to tell if it got contaminated? The knocking kinda sounds like it's coming from the flywheel or torque converter area

Thanks again for all the tips. I ended up borrowing another Holley carb from a friend and once I installed it today the motor fired up and idled great. Except for now there is a terrible knocking sound coming from inside my motor! I am almost in disbelief because I've spent so much time and...

Yeah I think I have the float bows adjusted good now. At first when you took the sight screw out the leaked quite a bit. I did some research and adjusted both of them to where they would only trickle out a tiny bit of gas when the site plug is removed. I'm starting to think I may be better off...

I'm located in Burlington. Only shop in my area that seems to know about this stuff is nortern performance. They seem pretty reputable

Well you should try living up here in Canada where it will be fully legal by next July. Still not legal to travel with a bong in public.. but still legal lol