Recent content by Dayzedandkonfuzed

  1. Dayzedandkonfuzed

    ECM Short?

    I have a pretty good understanding of electronics and circuit boards, at least enough to be able to do some testing. I ended up pulling it right out and following the circuit. First 2 diodes in line after the pin were fried, and they were obviously set up as short circuit protection. I couldn't...
  2. Dayzedandkonfuzed

    ECM Short?

    Okay okay, not gbody related but close. I'm working on the neighbors 91 s10 and have found there is a short in the main feed to the fuel pump relay and oil pressure sender. Relay and sender unplugged, wire still shorted to ground. ECM unplugged, wire no longer shorted. So I've found that pins...
  3. Dayzedandkonfuzed

    bbc el camino needs stout front springs - what would work?

    Any update on this? Would love to see what you chose and how it looks. Just found out that the s10 drop springs I installed aren't the best option for my big block malibu. Riding on the bump stops now which has caused them to move around a little bit...
  4. Dayzedandkonfuzed

    Propane Powered Drag Car Question

    What they said^^^ Also acts as a failsafe to overheating. If they're mounted at or near the highest point, your fuel freezes and the car stalls before the engine overheats in the event of coolant loss. Not that this was engineered into them, just a byproduct. Ask me how I know.
  5. Dayzedandkonfuzed

    MALIBU Who likes strippers?

    And here I thought I'd find a conversation about electrical tools. Man was I disappointed.
  6. Dayzedandkonfuzed

    Worst Vehicle Ever

    Sorry, our bad.
  7. Dayzedandkonfuzed

    Worst Vehicle Ever

    That may be true, but at least I can still buy parts for a Chrysler that is 10 years old. Anyone remember the Lada cars that had an engine tick nobody could figure out? Rumor has it there was a reward (like 50k or something) for anyone that found the problem. I'm not sure it was ever found or...
  8. Dayzedandkonfuzed

    MALIBU Fan tastic

    Hey! Me too!
  9. Dayzedandkonfuzed

    MALIBU Fan tastic

    Depends on your setup. Most electric fans are not recommended for 4 core rads as they work too hard to pull through and can't deliver the CFMs. But they look much cleaner. If you're building something extreme that's gonna go over 7k rpm's often, an electric is likely the safer option than a...
  10. Dayzedandkonfuzed

    2010 Sierra - need some info

    Now this I like the sound of.
  11. Dayzedandkonfuzed

    2010 Sierra - need some info

    Thanks for all the info. Sounds like my best option is to rebuild the one in it myself, with the upgraded drum. Don't worry, I'll have an experienced transmission tech helping me. Or maybe I'll just yank it out pay him to do it. This is assuming, of course, that this truck is still available...
  12. Dayzedandkonfuzed

    2010 Sierra - need some info

    So I'm looking at this 2010 sierra 1500 for sale. 4x4, 5.3 flex fuel truck, so it should have a 4L60 as far as I can tell. Ad says the trans is sometimes hesitant and starting to slip. So worst case this rig needs a transmission. I'm not at all afraid of this job, but what issues might I run...
  13. Dayzedandkonfuzed

    1984 H/O ??FAKE?? sold at Mecum

    I see this all the time with 'Bandit' trans-ams. Once saw a 79-81 convertible with a 77-78 nose on it, being sold as a 77 factory original numbers matching "ultra mega rare blah blah blah." Firebirds didn't come in a convertible between 1970 and 1988. It looked well done, and would likely have...
  14. Dayzedandkonfuzed

    turn signals no work

    Did you replace it with the one I mentioned? And did you ground the wire coming out of it to a verified good ground? I'll give you the run down here. A flasher is built to recognize when a light is burnt out. It does this by sensing the electrical load passing through it. LED bulbs require much...
  15. Dayzedandkonfuzed

    Funny Car Related meme's

    Wouldn't happen with a Cybertruck!
See more

Please support GBodyForum Sponsors

Classic Truck Consoles Dixie Restoration Depot UMI Performance

Contact [email protected] for info on becoming a sponsor

Top Bottom