Last edited:
dyno time,lets hear the guesses.
- Thread starter melloelky
- Start date
see? my butt-dyno would have said "Yeeeeeeeee-hawwwwww".....and been just as accurate!
Impressive numbers! Congratulations!!
Too bad that the yellow bulbs in the traffic lights are wired in the wrong order...
Thanks.this went better than my last one and hopefully it lasts longer 😄
I was suprised because it was a solid rolled 406 vs this smaller 383.the torque curve starts pretty close to that one but with 30 more ftlb.im not much of a motor build /dyno guy but I'm feeling good about it all.
Those AFRs have awesome port velocity , late to the WAG thread. figured you'd be around 5-525 on both sides.. seams I was little low as I kept scrolling..
Add some fuel injection setup and you'll hurt some LS feelings 😎
Add some fuel injection setup and you'll hurt some LS feelings 😎
Most people over carb their engine... And it's 524/534 per post #11 😉
FWIW 383 at 6000rpm and 100%VE is roughly 625cfm
Similar threads
