i have been using one for three years now, very close to headers. when i was pushing into garage the steering was making funny noise, when i turned the steering wheel the tires didn't turn. turned out to be the rubber near the top was slipping, put a bolt thru that part where the rubber was...
on my 1988 monte ss i have installed UMI part # 3035 front 1 1/4" sway bar, tighten up the front end a bunch. 3044-275 UMI rear sway, this bar attachs to the bottom of the axel tube of the rear end, works great and easy to set up. using the UMI upper control arm #3056, this has the adustable rod...
i am trying a new steering set up for 88 monte.. did the math on parallel steering (stock set up) 5 degee pitman turn left (8 degree at tire) came out 5 DEGREE TOE OUT (that is 2 1/2 inch toe out). inches are half to degrees. 10 degree left turn (13 degree at tire) 5 1/2 DEGREE TOE OUT, fifteen...
i notice a flat part on the shock mount about 1 1/2" inboard and around 45 degree angle from origional shock hole. i drille the new hole a 1/4" lover than the stock mount hole, the hard part was getting the shock mounting hole to go at a downward angle to align the upper and lower mounts so as...
by using the 1990 camaro centerlink , the tie rods are now level with ground. i was able to cut 2" off the lenth of the tie rods, i cut 1 1/2" off the outer, and 1/2" off the inners. on the inners i had to run a die down for 1 1/2" of new threads, my buddys were a bigger diameter so we had to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.