Search results

I have a 81 chevy malibu on 26s evertime the shop go into reverse the car takes a nose dive can anybody tell me why What correct setup do I need to Carry that kind of load

Well I have the rims already and I am looking for the donk look I was hoping someone that did it already saw my post and give me the recipe

AND THAT IS WHY THIS BUILD WILL BE SPECTACULAR BECAUSE ALL U NEGATIVE PEOPLE ACTUALLY GIVE ME THE FUEL TO MAKE IT HAPPEN SO I THANK ALL U BROKE HAITER THAT CANT AFFORD TO BUILD SUCK A WONDERFUL CAR THANK U 🤣🤣

Where are u located and was ur shops num

Yeah I have it written down I'll get back to u on that

The rear is 26x10 with a 5 inch lip and the front is 26x9 with a 3 inch lip

Yeah I spoke to amani forged and they told me just lift it a few inches and i will be fine but they never mentioned anything about the turning ratio i have trailing arms upper and lower

Thanks

Damn I did it this time and I'm really stuck with these rims smh

Yeah if I have to wait longer I will I need the rims to be flushed with the fender

So u think 3 inch lift cups would work with the original springs

😥 I went into this build not knowing what I was up against I already paid a ton of $ for my rims now I have to forward thank u for ur advice

Thank u I brought a 2002 Silverado just for the motor but I junked the truck wish I would have known this smh

I already ordered rims from armani forged so I can only go forward

Thank u but I was try not to do so much cutting in the rear

I have a 81 chevy malibu I'm trying to put 26s on it was the best was to make them fit with minimal to no cutting and would a suspension from a different car fit?