1978 1979 1980 oldsmobile cutlass

  1. G

    edelbrock 650 for 305 sbc

    Good afternoon, I am planning on installing a edelbrock 650 for my 305 sbc. If possible can anyone give me advice, dos and don’ts of this. Any information would be great. I’m going this route due to installing hydraulics in the near future. I do not want to have a carburetor on it to avoid...
  2. G

    1978 Oldsmobile Cutlass Calais

    Good evening! I am a young buck with my first old school! I plan on turning my cutlass into a lowrider. Obviously, it's timing consuming and takes a lot of planning and saving of money. I was lucky enough to swoop on my first set of rims from one of my uncles that knows nothing about lowriders...
    • GHobbit13
    • Thread
    • 100spokes 1978 1979 1980 oldsmobile cutlass cutlass cutlass calais lowrider
    • Replies: 2
    • Forum: General Discussion
  3. A

    Help! Can't find vinyl top moulding for 80' cutlass

    Hi there, I know a lady in her 70's that owns a 1980 Cutlass Supreme - Landau (Yep, she a very cool older lady) and she has been searching for the vinyl top moulding that runs up pillar B without much luck. She did manage to get a part number from a dealership though. #20066298 She doesn't...
    • arcy
    • Thread
    • 1978 1979 1980 oldsmobile cutlass cutlass landau vinyl top
    • Replies: 12
    • Forum: General Discussion
  4. C

    Just bought a 5 speed cutlass

    I just bought a 78 cutlass Calais with a 5 speed manual and the 260 v8 for $2,000. I have a few questions... 1. Did I get screwed over? The car runs and drives perfect, interior is ehhh and the exterior is also ehhh 2. My car is a factory 5 speed (It even says so on the build sheet) and I want...
  5. H

    Location of ECT sensor

    When cold starting my 1978 Cutlass Supreme... 4.3l 260 v8 engine... my Hot light comes on and stays on. I figured it was the ECT (engine coolant temperature ) sensor, I need to know its location. Is it the one in the intake manifold or the one behind the water pump? This is a picture of an Olds...
  6. 78factory5

    78-80 cutlass fiberglass bumpers

    There seems to be a couple places offering these bumpers. Any suggestions or reviews on quality, fit and finish is appreciated.

Please support GBodyForum Sponsors

Classic Truck Consoles Dixie Restoration Depot UMI Performance

Contact [email protected] for info on becoming a sponsor

Top Bottom