1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

84 H/O rock/chip guard pictures???

Discussion in 'Oldsmobile Cutlass / 442 / Hurst/Olds' started by Evan11, Apr 8, 2017.

  1. DROLDS84

    DROLDS84 Apprentice

    Joined:
    Feb 15, 2015
    Messages:
    97
    Likes Received:
    85
    Trophy Points:
    18
    Location:
    SW Michigan
    Pretty sure the coatings are designed to spray on,let them cure per manufacturers directions and then base and clear.You don't have to use 3M...there are a lot of other brands out there.
     
  2. 88hurstolds

    88hurstolds Royal Smart Person

    Joined:
    Jun 24, 2008
    Messages:
    1,660
    Likes Received:
    80
    Trophy Points:
    48
    3/4" to 1" below the body line for all VIN9 cars.
    Factory was sloppy when they applied paint and stripes so cars will vary, the rock guard line can be wavy and fade.
    No rock guard on rear fenders but some '84 H/O's had them, again, factory was sloppy...
     
    #12 88hurstolds, Apr 19, 2017
    Last edited: Apr 19, 2017
  3. 88hurstolds

    88hurstolds Royal Smart Person

    Joined:
    Jun 24, 2008
    Messages:
    1,660
    Likes Received:
    80
    Trophy Points:
    48
    Looked at my friends '83 H/O survivor and the rock guard was all over the place... on the passengers side it went up to the stripe, on the drivers it was about 1/4" below the stripe.
    The fenders had a little over spray of the rock guard towards the top by the stripe but none on the bottom of the fenders.
    It's a mess...
     
Loading...

Share This Page