just got my 84 buick out the shop "wiring" well it was fine i drove it parked it now i try to crank it and its does not start i have a new fuel filter what else could be the problem? i see slight leaking from me intake were it sits on my block i was wondering is it worth the effort just for a slight drip ?i mean it not going to just go crazy and leak all over the place can i wait till its more pronounced.reason being i ready to drive and dont want to send it back to the shop again.
age old question and new one ? turns but will not start
- Thread starter palehorse78
- Start date
- Status
tc1959 said:
x2. If you mess with it first, they may say you caused the problem and then they will charge you for it.
What was it in the shop for to begin with?
Most of the time when I see this on an older car it ends up being fuel related or the ignition module has gone bad.
And when you say leak, is it oil or antifreeze? If it's oil, tell us which engine is in the car. I'm guessing sbc with an intake swap if it's oil.
Most of the time when I see this on an older car it ends up being fuel related or the ignition module has gone bad.
And when you say leak, is it oil or antifreeze? If it's oil, tell us which engine is in the car. I'm guessing sbc with an intake swap if it's oil.
- Status
Similar threads
